How do I connect my Plantronics headset to Windows 7?

On your computer, click Start, and then click Devices and Printers. Note: Depending on your computer’s configuration, you may first have to click Control Panel, then Devices and Printers. Click Add a Device. The Add a Device windows appears, and immediately starts searching for your headset.

How do I pair my Plantronics Voyager Pro UC?

Press and hold the power button for about 5-6 seconds until the light on the headset starts flashing an alternating red-blue. Release the power button and set the headset aside. Plug the Bluetooth USB adapter into the computer. Once the devices pair successfully, the light on the headset stops flashing.

How do I update the firmware on my Voyager focus?

*To achieve the greater range, the firmware must be updated on both the Voyager Focus Bluetooth headset and the BT600 USB dongle. Plug the USB dongle into the PC, and the headset turned on. Go to the ‘Updates’ section within Plantronics Hub software and update the firmware.

Does Windows 7 support Bluetooth headset?

To pair your Bluetooth headset to a Windows 7 computer: Make sure your computer’s Bluetooth chip supports the Headset or Handsfree Bluetooth profile (if your computer has a data-only Bluetooth profile, you cannot pair your headset to it). On your computer, click Start, and then click Devices and Printers.

How do I reset my Plantronics Voyager Legend?

Reset Plantronics Bluetooth Headset

1. Remove the Plantronics headset from your cell phones paired devices.
2. Power your cell phone off, then power it back on.
3. Pair your Plantronics headset back to your cell phone (follow manual if unsure how)
4. Your Plantronics headset should now be reset.

How do I contact Plantronics?

1 (855) 765-7878
Plantronics/Customer service

How do I connect my Plantronics Voyager to my computer?

Press and hold the call control button for about 5-6 seconds until the light on the headset starts flashing an alternating red-blue. Release the call control button and set the headset aside. Plug the Bluetooth USB adapter into the computer. Once the devices pair successfully, the light on the headset stops flashing.

How do I reset my Plantronics Voyager?

Hold down the MINUS (-) volume control and the black power button at the same time until the blue light goes out. Step 3 Wait 1 minute for the reset to power down the software and clear firmware. Step 4. Power back up as normal.

How do I install Bluetooth drivers on Windows 7?

Before you start, make sure that your Windows 7 PC supports Bluetooth.

1. Turn on your Bluetooth device and make it discoverable. The way you make it discoverable depends on the device.
2. Select Start. > Devices and Printers.
3. Select Add a device > select the device > Next.
4. Follow any other instructions that might appear.